Compound Y has a distribution coefficient of 4.0 when extracted from water with chloroform, with Y being more soluble in chloroform. How many 10.0 mL chloroform extractions would be required to extract at least 95% of Y from a 50.0 mL aqueous solution of water?

Answer:

14.57g

Explanation:

Given parameters:

Mass of dish + ball  = 15.6g

Initial volume of water in the cylinder  = 26.7mL  

Final volume of water in the cylinder  = 38.9mL

Mass of dish = ?

Unknown

Mass of the ball = ?

Solution;

 Since the mass of ball and dish is 15.6g,

 Mass of the ball  =Mass of ball + dish  - mass of the dish

 Insert the parameters and solve;

 Mass of the ball  = 15.6g  - 1.03g  = 14.57g

Answer:

so i got 34.5

Explanation:

Answer:

[tex]Fe_2O_3(s)+3H_2(g)\rightarrow 2Fe(s)+3H_2O(l)[/tex]

Explanation:

Hello!

In this case, when writing chemical reactions from the given names we must make sure we know the proper formula for each reacted and produced species; thus, since solid iron (III) oxide is [tex]Fe_2O_3[/tex], hydrogen gas is [tex]H_2[/tex], solid iron is Fe and liquid water is just [tex]H_2O[/tex], we can write:

[tex]Fe_2O_3(s)+H_2(g)\rightarrow Fe(s)+H_2O(l)[/tex]

However, since different amount of atoms of iron, hydrogen and oxygen are present at each side of the equation, we balance it by adding the following coefficients to each molecule:

[tex]Fe_2O_3(s)+3H_2(g)\rightarrow 2Fe(s)+3H_2O(l)[/tex]

And now it is balanced with two iron atoms, three oxygen atoms and six hydrogen atoms at both reactants and products.

Best regards!

Answer:

This question appears incomplete

Explanation:

There is no such element known as "Ballardium (Bu)" in the periodic table. However, there are elements with a bit of similarity in spellings and pronunciation such as Beryllium (Be) which is found in group 2 (meaning it is an alkali earth metal), Berkelium (Bk) which is an actinide (meaning it is radioactive) and Vanadium (V) which is found in group 5 of the periodic table (meaning it's a transition metal).

Answer:

Tollen's test or silver mirror test is use to distinguish between ketone and aldehyde.

Explanation:

Tollen's test is use to distinguish aldehyde from ketone because Tollen reagent consist of silver nitrate and ammonia and it oxidized aldehydes to carboxylic acid and the silver Ag+ is reduced to solid silver Ag. It form a inner film wall on the tube that look like mirror. Ketone do not react with Tollen reagent and therefore does not form silver mirror on the tube wall.

Explanation:

A chemical property of soda ash is, it is a alkaline compound

the titration is the most important part in determining whether

Answer:

Molecular movement

Explanation:

When an object gets hotter, its molecules gain more kinetic energy and then move faster. Therefore, the fast-moving molecules will cause those around them to move faster as well, and the colder (or more slow-moving molecule object) object or part is heated up.

PLS GIVE BRAINLIEST

actual yield = 0.182 mole

theoretical yield : 0.484 mole

percentage mole(% yield)=37.6%

Percent yield is the comparison of the amount of product obtained from a reaction with the amount you calculated

General formula:

Percent yield = (Actual yield / theoretical yield )x 100%

An actual yield is the amount of product actually produced by the reaction. A theoretical yield is the amount of product that you calculate from the reaction equation according to the product and reactant coefficients

Reaction

Fe₂O₃+3C⟶2Fe+3CO

a. actual yield of Fe mole

10.2 g produced

[tex]\tt mol~Fe=\dfrac{10.2}{56}=0.182[/tex]

b. percentage mole and theoretical yield

0.242 mol Fe₂O₃ = 2 x 0.242 mol Fe = 0.484 mol (theoretical yield)

percentage yieldpercentage mole)

[tex]\tt \dfrac{0.182}{0.484}=0.376=37.6\%[/tex]

Answer:

7.44%

Explanation:

[tex]\frac{6.44}{6.44+80.1} *100=7.44[/tex]

Answer:

Ne is the identity of the gas

Answer:

I do not bake but my mom is a professional baker.  

Explanation:

A roof over my head and a warm home.

Plenty of drinkable water.

I don't have to go hungry.

I can enjoy the small and free pleasures of life.

Access to the internet.

My friends and family.

My health.

The kindness of people I have never met before.

Answer:

D unbalanced force

Explanation:

i think

Explanation:

Conversion -

CH₃–CH₂–OH → CH₃–CH₂– CH(OH)–CH₃

Explaination -

CH₃–CH₂–OH + HCl → CH₃–CH₂– Cl + H₂O

Now,

CH₃–CH₂– Cl + 2Na + Cl–CH₂–CH₃ → CH₃–CH₂–CH₂–CH₃ + 2NaCl (wurtz reaction)

Now,

CH₃–CH₂–CH₂–CH₃ + Cl₂ → CH₃–CH₂–CH₂–CH₂–Cl + HCl (Halogenation)

Now,

CH₃–CH₂–CH₂–CH₂–Cl + KOH (alc.) → CH₃–CH₂–CH=CH₂ + KCl + H₂O

Now,

CH₃–CH₂–CH=CH₂ + H₂O → CH₃–CH₂–CH(OH)–CH₃ (Hydration of alkene by MR addition rule)

Answer:

52.8 g of O2.

Explanation:

We'll begin by writing the balanced equation for the reaction. This is illustrated below:

4Al + 3O2 —> 2Al2O3

From the balanced equation above,

4 moles of Al reacted with 3 moles of O2 to produce 2 moles of Al2O3

Next, we shall determine the number of mole of O2 needed to react with 2.2 moles of Al. This can be obtained as follow:

From the balanced equation above,

4 moles of Al reacted with 3 moles of O2.

Therefore, 2.2 moles of Al will react with = (2.2 × 3)/4 = 1.65 moles of O2.

Thus, 1.65 moles of O2 is needed for the reaction.

Finally, we shall determine the mass of O2 needed as shown below:

Mole of O2 = 1.65 moles

Molar mass of O2 = 2 × 16= 32 g/mol

Mass of O2 =?

Mole = mass/Molar mass

1.65 = mass of O2 /32

Cross multiply

Mass of O2 = 1.65 × 32

Mass of O2 = 52.8 g

Therefore, 52.8 g of O2 is needed for the reaction.

Answer:

Explanation:

C = 49.48

H = 5.19

O = 16.48

N = 28.85

ratio of moles

= 49.48 / 12 : 5.19 / 1 : 16.48 / 16 : 28.85 / 14

= 4.123 : 5.19 : 1.03 : 2.06

= 4 : 5 : 1 : 2

so the empirical formula = C₄ H₅O N₂

Let molecular formula = (  C₄ H₅ON₂ )ₙ ,

n ( 48 + 5 + 16 + 28 ) = 119.19

97 n = 194.19

n = 2 ( approx )

molecular formula = C₈ H₁₀O₂ N₄

Answer:

2.51x10⁻⁵ mmol MgF2/L

Explanation:

To find the concentration in mmol / L we need to convert μmol to mmol (1000μmol / 1mmol) and mL to Liters (1000mL / 1L) as follows:

μmol MgF2:

0.0113μmol MgF2 * (1mmol / 1000μmol) = 1.13x10⁻⁵ mmol MgF2

Liters solution:

450mL * (1L / 1000mL) = 0.450L

Concentration in mmol/L:

1.13x10⁻⁵ mmol MgF2 / 0.450L =

Answer:

pH = 4.79

Explanation:

The equilibrium of benzoic acid, BH, is:

BH ⇄ B⁻ + H⁺

Where B⁻ is benzoate anion

Where the dissociation equilibrium, Ka, is:

Ka = 6.46x10⁻⁵ = [B⁻] [H⁺] / [BH]

If 20.0% is B⁻, 80.0% is BH, replacing:

6.46x10⁻⁵ = [20.0%] [H⁺] / [80.0%]

1.615x10⁻⁵ = [H⁺]

As pH = -log [H⁺]

Answer:

i can only help with 2 :( atimic mass is: 35.453  and number of electrons is:17

Explanation:

Answer:

q

Explanation:

We are given:

P1 = 1 atm                 P2 = 3 atm

T1 = 300 K               T2 = 600 K

V1 = 6 L                    V2 = v L

Finding the final Volume:

From the ideal gas equation:

PV = nRT

since in the given scenario, the universal gas constant (R) and number of moles(n) are constant

So, for both the cases, the value of n*R will be a constant k

Hence, we can write that:

PV / T = k        [where k is a constant]

Since the constant 'k' is the same for both the cases, we can write that:

P1V1 / T1 = P2V2 / T2

replacing the variables

1 * 6 / 300 = 3 * v / 600

1/50 = v / 200

v = 200/50

v = 4 L

Therefore, the volume of the gas at 600K and 3 atm will have a volume of 4 L

Answer:

i am not sure but it seems D is the best

Answer:

A

Explanation:

It seems to be the most logical. My reasoning is that for B when it uses one parent cookie that produced genetically different offspring. That is what makes it incorrect. The other two options involve two parents which means that the reproduction would be sexual. A. would be the closest to the answer.

Please let me know if this is correct! Hope it helped.

Answer:

V₂ = 4.4 L

Explanation:

Given data:

Initial volume = 5.5 L

Initial pressure = 650 mmHg (650/760 =0.86 atm)

Initial temperature = 20 °C (20 +273 = 293 K)

Final temperature = 273 K

Final volume = ?

Final pressure =  1 atm

Solution:

Formula:  

P₁V₁/T₁ = P₂V₂/T₂  

V₂ =  P₁V₁T₂/T₁ P₂

V₂ = 0.86 atm× 5.5 L × 273 K / 293 k × 1 atm

V₂ = 1291.29 atm.K.L / 293 k.atm

V₂ = 4.4 L

Answer:

protons and neutrons are located in the nucleus.

Answer:

first and 3rd are ur answers

Answer:

they use it when a living organism dies.

Explanation:

when d organism decomposes carbon is released that enters back into d earth. this follows d law of mass

Answer:

3,686,400,000 Joules

Explanation:

Energy = 1024 kWh

To be converted to Joules.

The relationship between kwh and joules is;

1 kilowatt-hour = 3600000 J

So we have;

1 = 3600000

1024 = x

x = 1024 * 3600000

x = 3,686,400,000 Joules

Answer:

Water has a higher boiling point because the hydrogen bonds that form water molecules are stronger than the Van der Waals interactions among methane molecules, therefor more energy must be provided in order to break the hydrogen bonds and allow the water molecules to escape the liquid state.

Explanation:

Water has a much higher boiling point than methane because only Van der Waals forces exist between methane molecules.​

Chemical bonds are forces of attraction between ions, molecules, and atoms.

There are different types of bonds present

Covalent bonds are the strongest bonds.

The molecules of water are joined by a hydrogen bond, thus its boiling point is high.

The molecules of Methane are attached by the van der Waals force, and it is weaker than the hydrogen bond.

Thus, methane has a lower boiling point than water.

Weaker bonds easily get broken.

Thus, the correct option is D.

Learn more about Chemical bonds

https://brainly.com/question/6071754

Answer:

The mechanism is E1 and the product is cyclohexene

Explanation:

Attached to this answer is an image of the reaction mechanism of the reaction between cyclohexanol and concentrated sulfuric acid/phosphoric acid. The acid (H3O^+) acts as catalyst.

We can see that the first step in the mechanism is the protonation of the -OH group of the alcohol. This is followed by loss of water molecule which is a good leaving group.

The water now acts as a Lewis base by abstracting a proton from the substrate, forming cyclohexene and regenerating the acid catalyst.