Moral of the story The Big Story by George Loveridge
how is that a question??????
4. Long term marijuana use can cause
please help me plz ill give 100 points and do something nice i need this done today plzz
Conditioned describes a space that's heated and cooled with the rest of the house. An unconditioned space is not heated or cooled so it's the same temperature (roughly) as outdoor air.
When a car engine is running, make sure that ______________. *
Answer:
Transmission fluid level
Explanation:
Answer:
make sure its in park unless youre in the vehicle
Explanation:
AAAAAAA CAR IS RUN WAY AAA CATCH CAR
Lenore's HVAC is putting in a system in a two-family residence. The control system being used is common, and will consist of a sensor, controller, controlled device, and
a) vents
b) insulated ducts
c) a chiller
d) an energy source
Answer:
d) an energy source
pf
This is correct!!! God bless!!!
i have two numbers that sum to 16 and have a difference of 3. by forming two equations and solving them, find the two numbers
Answer:
(x=9.5 and y=6.5) or ( x=6.5 and y = 9.5)
Explanation:
Let equations be
x+y = 16
If
x-y = 3
Now, Adding both equations, we get
x+y+x-y = 16+3
2x = 19
x=19/2 = 9.5
y = 16-9.5 = 6.5
Now y-x = 3
Now, Adding both equations, we get
x+y+y-x = 16+3
2y = 19
y=19/2 = 9.5
x = 16-9.5 = 6.5
Information such as tolerances and scale can be found in the _______________ of an engineering drawing.
Answer:
Information such as tolerance and scale can be found in the title block of an engineering drawing
Explanation:
The title block of an engineering drawing can normally be found on the lower right and corner of an engineering drawing and it carries the information that are used to specify details that are specific the drawing including, the name of the project, the name of the designer, the name of the client, the sheet number, the drawing tolerance, the scale, the issue date, and other relevant information, required to link the drawing with the actual structure or item
Shondra’s family’s monthly net income is $6,654. The family’s budget is shown in the circle graph below. The family decides to increase the savings budget by 3 percent by decreasing one of the variable expenses by 3 percent.
Answer:
$466
Explanation:
What is the difference between non profit making organizations and profit making organizations
Answer:
non profit making organizations are free while profit making are not free
THE LINE IS USED TO SHOW IMPORTANT OVERHEAD CONSTRUCTION.
A. PHANTOM
B. HIDDEN
C. EXTENSION
D. CENTER
Answer:
phantom
Explanation:
phantom is the option
what is meant by engineering jobs
Answer:
Engineers work in a variety of fields to analyze, develop and evaluate large-scale, complex systems. This can mean and improve and maintaining current systems or creating brand new projects. Engineers will design and draft blueprints, visit systems in the field and manage projects.
essay about the topic that says shop should be closed on Sundays
Answer:
Do you mean writing about shops that close on Sunday's and making the opinion whether they should or not?
Explanation:
If you are being followed too closely while driving, you should
Answer:
Merge into a different lane.
Explanation:
The safest and most logical choice to this question would be to merge into a different lane, not speed up over the speed limit and not slow down and aggravate the driver behind you.
.Match the benefit of full synthetic oil with engine conditions: If oil is thicker, engines lose power and efficiency.
A) Synthetic improves engine protection by resisting oil breakdown.
B) Synthetic has greater resistance to oil thickening to maintain engine efficiency.
C) Synthetic provides maximum protection in extreme hot and cold temperature conditions
Synthetic has greater resistance to oil thickening to maintain engine efficiency. The correct option is B.
What is engine efficiency?An engine's efficiency is defined as the ratio of useful work done to heat provided is the completed work Please keep in mind that the term "work done" refers to the power delivered at the clutch or driveshaft.
This means that the work done by thermodynamic expansion is reduced by friction and other losses.
Lower viscosity without sacrificing wear protection and better cold-flow, both of which improve fuel economy, are possible with synthetic oil.
Thus, the correct option is B.
For more details regarding engine efficiency, visit:
https://brainly.com/question/13154811
#SPJ1
Select the correct answer.
Read the quote.
"Why do most people choose to vacation in the mountains? Simply because the climate is perfect, and the sights are soothing."
Which rhetorical device does the speaker use?
emotional appeal
rhetorical question
metaphor
allusion
The rhetorical device the speaker used is: "emotional appeal" (Option A). Another word for this is called pathos.
What is pathos?Pathos appeals to the audience's emotions and values, eliciting feelings that they already have. Pathos is a rhetorical term that is also employed in literature, film, and other forms of narrative art.
Pathos, or the appeal to emotion, is to persuade an audience by invoking specific emotions in order to make them feel the way the author wants them to feel. Authors utilize intentional wording, meaningful language, and examples and tales that elicit emotion.
Learn more about rhetorical devices:
https://brainly.com/question/518481
#SPJ1
Answer:
rhetorical question
Explanation:
got 100%
Construction engineers develop a clear
scope of the environment for the
construction project using which of the
following?
A. GPS
B. Blueprints
C. Drafting
Answer:
B. Blueprints
Explanation:
What is the correct sequence of steps for restoring equipment to service in a typical minimal lockout procedure? Possible answers?
B, A, C, D, E
C, B, A, E, D
D, C, B, A, E
A, C, B, E, D
The correct sequence of steps for restoring equipment to service in a typical minimal lockout procedure is option a: B, A, C, D, E.
What is lock out procedure?The term “lockout tagout” is known to be a term that is particularly made to any form of procedures that are often used to make sure that equipment is shut down as well as inoperable and this is often done until maintenance as well as repair work is known to have been completed.
Note that this is often used so as to keep employees safe from the hazard of use of any equipment or machinery that could bring about injury or even kill them if not handled correctly.
Note also that
STEP 1: Notify affected employees and then tell them to set back. other steps will follow. Therefore, The correct sequence of steps for restoring equipment to service in a typical minimal lockout procedure is option a: B, A, C, D, E.
Learn more about lockout procedure from
https://brainly.com/question/24573204
#SPJ1
When you adjust the controller's output to achieve the setpoint, what sort of system do you have?
Answer:
Modulating control
Explanation:
pf
hope this helps!
Imagine waking up every day and no one is home besides your dog and you how would you feel?
Answer:
I would be upset.... are you ok???
in a circuit 3resistor are connected in parallel R¹=10ohms R²=15ohms R³=30ohms 1. calculate total resistance 2. total current flow 3.voltge drop across each resistor 4.total dissipated by the circuit 5. power in the 15ohms
I'll give you the formula to calculate the net resistance of multiple resistors I'm in parallel.
1/R = 1/R1 + 1/R2 +1/R3 +……+1/Rn.
Take the reciprocal of each resistor value and add them up. The reciprocal value of a resistor is called its admittance. Add them up to get the total admittance. Notice that this value is 1/R. So take the reciprocal by dividing 1 by the total admittance value. Then you have the net resistance for all the parallel resistors.
Now you know the total resistance of the parallel values, if there are any other resistors in series with this, add them on to get the total resistance in the circuit.
Now use Ohm's law to find the current.
I =V/R
1. paralel resistance
1/(1/10+1/15+1/30)= 30/6=5 Ohms
2. total current : V/R=24/5= 4.8A
2. A
is a launched object that moves forward due to inertia and
accelerates downward due to gravity.
A. joule
B. nodule
C. phalange
D. projectile
is the curved path a launched object takes as it moves
PLEASE HELP! I AM TAKING A TEST
On a bicycle Chain and Sprocket: Which of the following gear ratios will give you the most Torque at
the back tire?
Driver 6"; Driven 6"
O Driver 6"; Driven 4"
O Driver 6"; Driven 2.5"
O Driver 2.5"; Driven 6"
Answer:
2.5
Explanation:
Think of one example where heat and friction are good outcomes of a process or machine. Identify the
specific cause of friction in this process and the object(s) that becomes hotter as a result.
Answer: 1. rubbing your hands together to keep warm in winter
2. the parts of a car engine rubbing together causes it to overheat sometimes
3. rubbing sticks together to make fire (it takes about two hours, but the stick gets hot)
How do you invite people to a covorsation
Answer:
just the way u did rn
Explanation:
lol
The term route of entry on sds refers to the way a Enters the body
Answer:Routes of Entry – The means by which a material may gain access to the body, for example, inhalation, ingestion, and skin contact. Safety Data Sheet (SDS) – The written or printed material concerning a hazardous chemical that is prepared in accordance with the HCS.
Explanation:
Daniel Wiseman, a scientist for Gres-Trans Corp., wants to determine if the flow rate of a particular material changes with different changes in temperature. The data is plotted in the figure below. What type of relationship exists between the flow rate and the change in temperature? negative curved positive there is no relationship
Answer: C. There is no relationship
Explanation:
At the various temperatures, the flow rates do not seem to show any relation as similar temperatures can yield different flow rates.
The flow rates neither appear to generally increase nor decrease as a result of a decrease or an increase in temperature which means that there is a lack of a positive, negative and curvilinear relationship.
There is simply no relationship.
Before starting you presentation, you should____?
Explanation:
Rehearse, rehearse, rehearse (always aloud) ...
Memorise your opening line. ...
Practise your speech from written notes. ...
Practise presentation flow. ...
The power of silence. ...
Have a backup. ...
Arrive early. ...
Use physical props for a demo.
Answer: introduce yourself or read the tilted
Explanation: you should introduce yourself first because tht let people know how going to be introducing the project or etc. I also say tilted because people need to know what you are going to be introducing to the class or teacher.
You want to create extra cleaning power for your muddy bicycle by mixing dish soap and bleach together.Your friend thinks that is a really, really bad idea because of something he heard. What should you and your friend do before you do this?Why?
Answer:
Come to terms of agreement after doing research and find the answer with expert based evidence because if not, you could cause more issues than needed if you do the wrong thing. Good Luck!
Column A
1.
2.
3.
4.
5.
-
-
Ohm's Law
Resistance
Current
Voltage
Ground
Question 9 (4 points)
Column B
a. The force or electrical pressure that has the potential to
cause electron flow in a circuit.
b. The physical phenomena arising from the behavior of
electrons and protons that is caused by the attraction of
particles with opposite charges and the repulsion of
particles with the same charge. The physical science of
such phenomena. Also, electric current used or regarded
as a source of power.
c. The opposition to current flow in a circuit; measured in
ohms.
d. Very basic circuit law that defines the relationships
between current, voltage, and resistance in a DC circuit.
e. The common return path for current in an electrical
circuit. Serves as a reference point for measuring all other
potentials in a circuit. Generally assumed to be at zero
potential with respect to the earth.
Answer / Explanation:
I am assuming the first column looks like
1. Ohm's Law
2. Resistance
3. Current
4. Voltage
5. Ground
This is typical circuit vocabulary,
1. d
2. c
3. b
4. a
5. e
What function does large volumes of moving water have in generating electricity
Answer:
Hydropower is a method of generating electricity that uses moving water (kinetic energy) to produce electricity. In large-scale hydropower plants the moving water drives large water turbines, and dams are needed to store water in lakes, reservoirs and rivers for later release.
Explanation: